Brandmotion FDMC-1221 - Manual

INSTALLATION
INSTRUCTIONS
1221Instructions 11-04-14.doc Page 1 of 5
2009 – Current F-150 flow though console models
Qi Wireless Charging Kit (Kit # FDMC-1221)
For use with Console Tray PN#(9L3Z-19A090-AA) and Mat PN#(9L3Z-1504G34-CB)
Please read thoroughly before starting installation and check that kit contents are complete.
Items Included in the Kit: Tools & Supplies Needed:
Qi Wireless Charging Module with
F-150 Specific Mat
8’ Power Harness with 3 amp Fuse
4 – Flat Head Torx 1/2" Screws
These Instructions with Template
Removable Consumer Product Label
Plastic Trim Removal Tool
T-10 Torx Driver
Phillips Screw Driver
Center Punch/Scribe Tool
Power Drill
5/32”, 3/16” and 1/2” Drill Bits
Razor Knife
Soldering Iron & Solder (Recommended)
Tape or Heat Shrink Electrical Tubing
82º Chamfer
*Note this product is designed to work with Qi compatible devices. Please confirm that
your device is Qi compatible before installation. Visit www.brandmotion.com for phone
compatibility guide.
Safety Precautions:
• Work in well ventilated area that is clear of obstructions.
• Secure vehicle with tire chucks in both front and rear of tires.
• Turn vehicle accessories OFF and ensure ignition key is in OFF position.
• Wear safety goggles and snug fitting clothes.
• Use tools only for their intended purpose and which are in good repair.
• Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation instructions.
For additional assistance please call Brandmotion Technical Assistance at (734) 619-1250 then dial 2.
IMPORTANT: Do not place smart keys
within 15cm of charging mat. Vehicle
may not detect key to start vehicle. Do
not place metal objects in tray while
charging.