Brandmotion 9002-8537 - Manual (Page 3)

INSTALLATION
INSTRUCTIONS
8537 Instructions 6-9-14.docx Page 3 of 4
Step 12: Route Camera Harness towards the side
of the vehicle that supplies power.
Step 13: Connect Camera Harness to supplied
Chassis Harness. The optimal location for this
junction may occur at the top of the liftgate or the
inner edge of the trunk. (Note: Most vehicles have
existing wires passing through this area; use this
route if at all possible).
Pinout Reference Chart
PIN
#
FUNCTION
CAMERA
HARNESS
COLOR
CHASSIS
HARNESS
COLOR
1
Video
(+)
Yellow
White
2
Shield
White
Blue
3
Reverse
Blue
Green
4
Video
(-­‐)
Brown
Brown
5
Ground
Black
Black
6
Ignition
Red
Red
Step 14: Route Chassis Harness forward. It may
be necessary to remove sill plates, pillar covers,
seat bases, side panels, etc. using a Plastic Trim
Removal Tool. In some cases, seatbelt bolts must
be removed. (CAUTION: Any bolts removed for
safety devices must be retightened to
manufacturer’s torque specifications).
Step 15: Determine location of vehicle Ignition
power and Ground. Using a multi-meter or
computer-safe test light, locate which side of the
vehicle contains the wires into which you will
connect Chassis Harness wiring (see chart below).
Chassis Harness Connection Chart
Wire
Color Polarity Function Description
Location
note
Red/
Green
12v +
Ignition
controlled
power
This lead
displays 12 volt
+ when the
key is in the
RUN position Commonly
found on
main
Ignition
harness.
Black (–) Ground Chassis ground
A ground
bolt is
commonly
found in
the front
kick panel
area with
other wires
attached.
Step 16: Secure Camera Harness to existing
vehicle wiring. This will minimize chance of binding
or otherwise damaging the harness.
RECOMMENDED: Wire Ties or Electrical Tape.
Step 17: Splice the red and green Chassis Harness
leads into the corresponding vehicle wires and the
black wire to chassis ground. (Note: Soldering
recommended or T-taps as optional connection
method). RECOMMENDED: Attach an eyelet to
the black ground wire.
Step 18: Use a Plastic Trim Removal Tool remove
lower driver knee bolster and upper dash visor
trim.