Brandmotion 9002-9510-V2 User Manual
Page 2
9510 Instructions 5-10-12
Tel
734-619-1250
2 of 3
Toll Free
877-276-6456
Fax
480-247-5999
Harness Pinout:
Pin
Wire Color
Function
1
N/A
N/A
2
N/A
N/A
3
Dark Green
Low Speed LAN
4
N/A
N/A
5
N/A
N/A
6
Red
Video +
7
Black
Video -
8
White
Ground
9
Brown
Reverse Signal 12V+
10
N/A
N/A
11
N/A
N/A
12
N/A
N/A
13
Green
Ignition Controlled 12V+
14
N/A
N/A
15
N/A
N/A
16
N/A
N/A
Wiring: (It may not be necessary for you to use the Green, White and Brown supplied wires below, most GM vehicles already
have these locations populated. If wires already exists in these locations simple test the leads using a multimeter for the
correct signal).
Inserting/ removing pins: located on the bottom side of the mirror connector is a rectangular white tab. This tab must first be
released (see figure 1). A small flathead watch repair screw driver works best. The tab will only lift about 1/10
th
of an inch.
Then insert the same screwdriver (or Delphi terminal tool 12094429) on the face of the connector and lift the plastic tab that
holds the pin in place (see figure 2).
Figure 1 Figure 2
White dot
identifies
cavity 1