Brandmotion 9002-9511 - Manual (Page 3)

9511 Instructions 9-18-12 Tel 734-619-1250
3 of 4 Toll Free 877-276-6456
Fax 480-247-5999
Pin 3 If present in vehicle it MUST be extracted and isolated (see Low Speed LAN note above)
Pin 8 Use Black wire from supplied harness and insert into connector, connect opposite end of wire to a good solid chassis
ground.
Pin 9 Use Green wire from supplied harness and insert into connector, connect opposite end of wire to the reverse lead from
the tail light circuit.
Pin 13 Use Red wire from supplied harness and insert into connector, connect opposite end of wire to the Ignition circuit of
vehicle. 12v+ when key is turned ON & 14.4 or better when vehicle is running.
Video signal: Connect RCA to camera video output. (See camera requriements above).
Pin 1 Camera video input positive- Insert White wire from supplied harness (the opossite end of wire is attached to the video
input RCA). Note: If lead exists in this cavity remove and isolate as it is not needed.
Pin 2 Camera video input negative- Insert Brown wire from supplied harness (the opossite end of wire is attached to the video
input RCA). Note: If lead exists in this cavity remove and isolate as it is not needed.
Temperature Probe (9002-6008) Note: If the mirror you are replacing already has a Temperature/ Compass display on the
right hand side of the glass you may not need to install the supplied probe. Check to see if there are already wires in cavities 6
& 7 and if so connect the mirror and if a temperature reading is displayed then you are done. If OC is displayed on LCD then
you must add temperature probe to vehicle.
Mount Temperature probe behind grille in a well ventilated area making sure that it is not close to the radiator for best
temperature reading.
Route the supplied cable through the firewall and up the A- pillar to the 16 pin connector (if the locking tab on the bottom on
the connector is set see Inserting/ removing pins instructions listed on Page 2 to release).
Insert the Red lead of the Temperature probe into cavity 6 and the Black lead into cavity 7.
Operation:
Temporary Monitor Manual Shut Down:
If while in reverse you require to turn OFF the camera monitor simply press and release the POWER button on the mirror.
(Note: once reverse is disengaged the mirror will go back to normal operation and will turn ON next time reverse is engaged).
Temperature and Compass Set up, Calibration and Testing (if equipped)
Your mirror maybe equipped with a screen which displays the current temperature as well as the current orientation of the
vehicle. Once the mirror is installed it is necessary to calibrate and test the function of these features.
Temperature settings:
The temperature may require approximately 20 -30 minutes after installation in order to achieve proper temperature reading.
The mirror can display either Fahrenheit or Celsius. In order to select either mode simply press and hold the POWER button
for 4 seconds until F or C appear, press POWER button to toggle between each mode and once correct reading is set wait 4
seconds and it will be stored on the mirror.