Brandmotion 9002-8522 - Manual (Page 3)

INSTALLATION
INSTRUCTIONS
8522 Instructions 7-10-13.doc Page 3 of 6
Step 8: Preload the screws into the Camera
Harness connector.
Step 9: Align the Camera Harness head so the key
lines up with the slot in the camera, and plug in the
connector. Snug the supplied screws with a Phillips
Screwdriver to create a watertight seal but do not
over tighten.
Step 10: Mount the Camera using the supplied
hardware. Insert the two Rubber Well Nuts into the
outer 5/16” camera mount holes.
Step 11: Thread the two supplied Bolts through
the Camera Mount and into the Well Nuts using a
Phillips Screwdriver but do not tighten the Bolts all
the way down just yet.
Step 12: Determine location of vehicle power and
reverse from the chart on Page 6.
Step 13: Route Camera Harness towards the side
of the vehicle that supplies power. It may be
necessary to remove sill plates, pillar covers, seat
bottoms, side panels, etc. In some cases even the
seatbelt bolts at the bottom of the pillars must be
removed.
CAUTION: Any bolts removed for safety devices
must be retightened to manufacturer’s specified
torque specifications). Use a plastic trim
removal tool to avoid damage to trim pieces.
Step 14: Connect Camera Harness to supplied
Chassis Harness.
The optimal location for this junction may occur at
the top of the liftgate or the inner edge of the
trunk. (Note: Most vehicles have existing wires
passing through this area; use this route if at all
possible).
Step 15: Route Chassis Harness forward. It
may be necessary to remove sill plates, pillar
covers, seat bases, side panels, etc. using a Plastic
Trim Removal Tool. In some cases, seatbelt bolts
must be removed. (CAUTION: Any bolts removed
for safety devices must be retightened to
manufacturer’s torque specifications).
Step 16: Secure Camera Harness to existing
vehicle wiring with supplied Wire Ties. This
will minimize chance of binding or otherwise
damaging the harness.