Brandmotion 9002-1015 - Manual (Page 6)

INSTALLATION
INSTRUCTIONS
1015 Instructions 11-14-13.doc 6 of 6
Figure 22
Secure Chassis Harness & Connect Camera
45. Route supplied Chassis Harness along existing
chassis harness toward rear of vehicle, staying clear
of body mounts. (Figure 23)
Figure 23
46. Connect supplied Chassis Harness to Tailgate Handle
Camera harness.
47. Secure supplied Chassis Harness along the existing
Chassis Harness using Wire Ties (recommended)
every 200mm (approximately 8”). Note: Depending
on vehicle wheelbase there may be excess length in
the Chassis Harness. Loop, and secure with Wire
Ties (recommended) or Electrical Tape, any excess
harness length along the Body Frame away from
Mechanical areas.
48. Reconnect negative battery terminal. Tighten
negative cable nut to 5 N·m (44 lb in).
49. Test system functionality: start vehicle, apply brake,
and shift into Reverse. The camera image should
appear in the supplied Mirror.
50. Re-install all previously removed trim.
MIRROR
OPERATION
1. To dim mirror, twist tab on bottom of mirror forward. To undim mirror, twist tab backward
2. Temporary Monitor Manual Shut Down:
If while in reverse you require to turn OFF the camera monitor, simply press and release the POWER
button on the back side of the mirror. (Note: Once reverse is disengaged the mirror will go back to
normal operation and will turn ON next time reverse is engaged).