Ambient Lockit Slate, ACN-LS - Manual (Page 22)

ACN-LS
©2014, Ambient Recording GmbH
20
ACN MENU
The ACN menu accesses the Ambient Clockit Network
configuration.
To enable ACN, select the MODE
Three different network communication modes are
available:
JAM, C-JAM, TX / RX
Once ACN is enabled, the clapped time is sent into
the network.
OFF: no wireless functions enabled.
ACN > JAM
The JAM mode allows to send a sync command to
other ACN-LS or ACL 204 devices or receive sync
command from them. This serves to remotely sync all
units on the set. First, the menu asks to select the
wireless channel.
The CHNL setting allows you to select between 16
network channels within the 2.4 GHz range.
The channel can be changed later.
After setting this, in ANT the low noise amplifier LNA
for the receiver may be enabled. The LNA draws
power, so it is recommended only should the
reception of data be insufficient without. If enabled,
LNA is indicated on the bottom right of the display.
PWR lets you increase the output power of the
transmitter. Default is 8 dBm, up to 18 dBm is
possible. Entering a PIN code required.