Ambient Lockit Slate, ACN-LS - Manual (Page 10)

ACN-LS
©2014, Ambient Recording GmbH
8
7. Setup Menu Diagram
When entering a menu, the active parameter setting is highlighted.
MAIN DISPLAY, showing time code, frame rate, sync rate, jam mode, network channel, battery status
↓ push select switch down to enter main menu and to select options, toggle left/right to navigate
↓
GEN ↓ JamTC ↔ Edit ↔ Offset
↓
JamTC: AUTO ↔ OFF ↔ manual/once
↓
Edit: HH:MM:SS:FF
↓
Offset: +/- 00.05 frames
↓
UB JamUB ↔ Edit-UB ↔ EXIT ↓
JamUB: normal ↔ manual ↔ insert
Edit-UB: 00:00:00:FF
EXIT: back to main menu
↓
SLATE ↓ SOURCE ↔ MODE ↔OFFSET ↔ SENS
↓
SOURCE: GEN ↔ LTC ↔ LTC-VARI ↔ ACN ↔ MTC
↓ ↓
MODE: DIGITS ↔ FLASH-LED DIGITS CLAPTIME ↔ UB+CLAPTIME ↔ NO CLAPTIME
FLASH-LED OFF ↔ CLAP FLASH ↔ CLAP
*
SECONDS
OFFSET +/- 00.05 frames
↓
SENS TILT ↔ BRIGHTNESS TILT On ↔ Off
BRIGHTNESS Man ↔ Low ↔ Med ↔ High
↓
TC ↓ FPS ↔ MTC ↔ Level
↓
FPS FPS: 23.976 ↔ 24 ↔ 25 ↔ 29.97 ↔ 30 ↔ 29.97D ↔ 30D
↓
MTC MTCout ↔ MIDI>LTC ↔ LTC>MIDI
↓
SYS ↓ Config ↔ INFO ↔ Factory reset
↓
Display ↔ USB ↔ BAT
↓
Display: Brightness: 0…↔5↔…10 ↓ AutoOff: never ↔ 5sec ↔ … ↔ 5min
↓
USB USB: MTC ↔ COM
↓
BAT Battery type: Li ↔ Alk ↔ NiMH
↓
INFO: displays device information: serial no., firmware version, mac address
↓
Factory Reset: loads default settings