Ambient Lockit - ACL 204 - Manual (Page 23)

21 www.ambient.de
ACN > TX / RX
TX is a wireless transmission of external time code
present on the Lemo/TC input. This is intended for
transmitting a record-run time code to another ACN-TL
or ACL 204 which is in RX mode.
Set up channel, antenna, RF power and LNA as above
in JAM mode.
Once progressing time code is detected, the ACL204
jams to it and sends a jam command to the slaves.
When external time code stops, a stop command is sent to the slaves.
If static time code value is recognized, as put out by a video camera or Sound Devices recorder, the
time code is stopped and a static time code is put out on the time code output of the slaves as well
as on the output of the unit that is in TX.
This feature makes it possible to remotely start and stop recording of audio recorders, cameras and
video recorders which support being triggered by time code.
Please note that in TX / RX record run time code
mode no sync signal will be generated
EXIT
Exits to the main operation screen.