Ambient Lockit - ACL 204 - Manual (Page 19)

17 www.ambient.de
SYS > CONFIG>BNC
Determine the output impedance for the video sync
signal:
Single: 75 Ohms for connecting to one video camera’s
genlock input.
Dual/3D: 37.5 Ohms for splitting to two cameras’ genlock input.
Select by toggling the config switch left/right. Push in to select mode.
SYS > CONFIG>USB
Default setting is MTC, the ACL 204 is recognized
as Midi/Audio interface when connected to
computer. Set to COM for updating.
SYS > CONFIG>BAT
Select battery type for correct voltage readout and low
battery warning / flashing.
Li = Lithium-Ion (non-rechargeable batteries!) 1,5V, Alk = alkaline batteries 1,5V, NiMH = Nickel-
Metal-Hydrid rechargeable batteries 1.2 V
SYS>INFO
Select INFO to display information about the
ACL204:
Serial Number
Main firmware version
FPGA firmware version
Mac address
SYS>Factory Reset
This restores factory defaults: Sync is off, TC is 25 fps,
ACN is off, display brightness at 3, display auto-off 30
sec., TC-offset reset, USB to MTC.
Time code is not lost, battery type not changed, tune
value unaltered.