Rockwell Automation Liqui-Flo 20-HIM-A6 with 2.0 AC Drive - Manual (Page 2)

2 Rockwell Automation Publication LIQFLO-UM011B-EN-P - November 2012
Using the 20-HIM-A6 HIM with the LiquiFlo 2.0 AC Drive
Installing and Removing the
HIM A cable, catalog number 20-HIM-H10, must be used to convert the HIM for
hand-held use. The maximum cable length is 9.7 m (32 ft) using extender cables.
To install the HIM on a Frame 3 Power Module, connect the HIM to DPI port
3 on the DPI Communication Interface board until it clicks into place. See
Figure 1 .
Figure 1 - Installing and Removing the Local HIM (Frame 3)
To install the HIM on a Frame 4 Power Module, connect the HIM to the HIM
adapter on the lower right corner of the power module. See
Figure 2 .
Figure 2 - Installing and Removing the Local HIM (Frame 4)
To remove the HIM, pull back on the HIM cable connector to release the HIM
from the DPI Communication Interface board.
 
DPI Communication
Interface board
DPI Port 3
20-HIM-A6 HIM
Connect HIM Here