beautypg.com

Using the start-up routines, Preparing for startup, Running the start-up routines – Rockwell Automation Liqui-Flo 20-HIM-A6 with 2.0 AC Drive User Manual

Page 15

background image

Rockwell Automation Publication LIQFLO-UM011B-EN-P - November 2012

15

Using the 20-HIM-A6 HIM with the LiquiFlo 2.0 AC Drive

Using the Start-up Routines

For standard applications, the start-up routines on the HIM enable you to
configure the most commonly used parameters through a series of steps. This
helps you set up the drive as quickly as possible.

For advanced applications, you may need to adjust additional parameters in the
parameter list using either the HIM or VS Utilities software.

Preparing for Startup

Before performing the start-up routine, you must:

Be qualified to configure the drive and be familiar with the operation of
AC drives.

Be familiar with the operation of the HIM.

Have completed all hardware installation.

Properly connect the drive to the motor.

Running the Start-up Routines

1.

Access the Status screen, which is displayed on HIM power up.

2.

If Port 00 (LiquiFlo 2.0) is not shown above the ESC soft key, use the

or

key to scroll to Port 00.

3.

Press the

key to display its last-viewed folder.

4.

Use the

or

key to scroll to scroll to the START UP folder.

5.

Use the

or

key to select Begin Start Up.

6.

Press the ENTER ‘soft key’ to acknowledge LiquiFlo Start-up.

ATTENTION: Only qualified electrical personnel familiar with the construction
and operation of this equipment and the hazards involved should install, adjust,
operate, or service this equipment. Read and understand this section in its
entirety before proceeding. Failure to observe this precaution could result in
severe bodily injury or loss of life.

ATTENTION: Incorrect values for some of the parameters in the start-up
routines can cause the drive to operate improperly. Verify that the values of
these parameters are appropriate for your application. Failure to observe this
precaution could result in bodily injury.

00

Stopped

0.00 Hz

AUTO

LiquiFlo 2.0

480V

900A

2.012 Ser. B

ESC

REF

TEXT

F

PAR#