Rockwell Automation Liqui-Flo 20-HIM-A6 with 2.0 AC Drive - Manual (Page 14)

14 Rockwell Automation Publication LIQFLO-UM011B-EN-P - November 2012
Using the 20-HIM-A6 HIM with the LiquiFlo 2.0 AC Drive
Viewing/Clearing Drive Faults or Alarms
To view and clear drive faults or alarms, perform the following steps.
1. Access the Status screen (see Figure 8 ).
2. If Port 00 (Host Drive) is not shown above the ESC ‘soft key’, use the
or key to scroll to Port 00.
3. Press the key to display its last-viewed folder.
4. Use the or key to scroll to the DIAGNOSTIC folder.
5. Use the or key to select Faults or Alarms.
6. Press the (Enter) key to display the numbered fault/alarm queue.
Faults/alarms are listed from the most recent (line 01) to occur to the least
recent. The fault/alarm number and name are shown at the right.
Figure 15 - Example Drive Fault Queue Screen
7. Use the or key or the following ‘soft keys’ to navigate within
the fault/alarm queue:
8. To clear faults/alarms, press the CLR ‘soft key’.
In the Select Action pop-up box, select the appropriate action using the
or key and press the (Enter) key to clear the active
fault/alarm or clear fault/alarm queue. To cancel the pop-up box, press the
ESC ‘soft key’ or select Cancel from the list and press the
(Enter)
key.
Soft Key Function
ENTER Displays the Time Stamp pop-up box for the fault/alarm.
Use the or key to scroll to all parameters related to the displayed fault/alarm
(if supported by device).
TOP Displays the first (most recent) fault/alarm in the queue.
END Displays the last (least recent) fault/alarm in the queue.
Faulted
0.00 Hz
AUTO
ESC TOP END
F
CLR
Port 00 Faults
01 207 Invtr Gate Kill
02 207 Invtr Gate Kill
03 207 Invtr Gate Kill
04 8 Invtr Base Temp
ENTER