Rockwell Automation CS3000 V6.1 MMI FlexPak, GV 3000, Liqui-Flo - Manual (Page 56)

6-4 Control and Configuration Software V6.1
6.4 Assigning Values to Parameters on the Drive
The Assign button assigns a value to the selected parameter. The assigned value is
displayed on the Parameter List screen and can be sent to the drive.
Important: The Assign function is available only when you are connected to a drive.
You cannot assign parameter values unless you are connected to a drive.
If you are not connected to a drive, the parameter list displays “
??? ” for all
parameter values.
When the drive is running, new values can be assigned only to tunable parameters.
For configurable parameters, the drive must be stopped before new values can be
assigned. Refer to the appropriate drive instruction manual to determine which
parameters are tunable.
When you select Assign or double-click on the parameters, a Parameter Assignment
dialog box is displayed. The options in this dialog box depend on the options for the
parameter.