Rockwell Automation 1797-Series ControlNet Ex Media Plannng Installation Manual - Manual (Page 49)

Publication CNET-IN003A-EN-P - January 2006
Install a ControlNet Ex Media System 3-7
Installation in Zone 1
The 1797-RPA and 1797-RPFM modules must not be exposed to the
environment. You must install these modules in a metal enclosure.
This repeater hub has a protection factor of IP20.
Electrostatic Charge
Protect the system against electrostatic charge. Post a sign near this
module. The sign should read
Attention! Avoid electrostatic charge.
For your convenience, see page C-1 for signs that you can cut out.
European Community Directive Compliance
If this product has the CE mark it is approved for installation within
the European Community or EEA regions. It has been designed and
tested to meet the following directives.
EMC Directive
This product is tested to meet the Council Directive 89/336/EC
Electromagnetic Compatibility (EMC) by applying the following
standards, in whole or in part, documented in a technical construction
file:
•
EN50081-2 EMC — Generic Emission Standard, Part 2 —
Industrial Environment
•
EN50082-2 EMC — Generic Immunity Standard, Part 2 —
Industrial Environment
This product is intended for use in an industrial environment.
ATTENTION
These modules cannot be used in a hazardous
environment after they have been exposed to
non-intrinsically-safe signals.
Attention: Avoid electrostatic charge.