Rockwell Automation 6189x Integrated Display Industrial Computers User Manual - Manual (Page 53)

Rockwell Automation Publication 6181P-UM003A-EN-P - May 2014 53
Component Replacement Chapter 4
5. Disconnect the eDP signal (C) and panel (D) cables from the panel
adapter board.
6. Lift the computer off the display panel (E).
7. Turn over the computer to access the PSU.
8. Remove the screws securing the two power connectors (F) from the PSU.
9. Disconnect the two power connectors.
IMPORTANT For display computers with aluminum bezels, do not disconnect the
USB 3.0 cable between the motherboard and front bezel USB port. If
necessary, cut cable ties so the computer can be ‘hinged’ into a safe
work position while the USB 3.0 cable remains connected.
The USB 3.0 cable is fragile so keep it connected to avoid any possible
damage. Replacement cable ties are supplied with the replacement
power supply.
C
D
E
DC Powered Integrated Display Model Shown
F
F