Rockwell Automation 6189x Integrated Display Industrial Computers User Manual - Manual (Page 46)

46 Rockwell Automation Publication 6181P-UM003A-EN-P - May 2014
Chapter 4 Component Replacement
Reinstall the Cover Follow these steps to reinstall the rear cover (a display computer is shown).
1. Follow steps 1…3 for
Post-configuration on page 45 .
2. Reattach the rear cover to the chassis (1).
3. Close the cover (2).
4. Tighten the three screws to secure the rear cover (3).
5. Follow steps 4 and 5 for
Post-configuration on page 45 .
CompactFlash Card The computers have a CompactFlash (CF) Type II card slot for loading CF cards
on the I/O port panel below the serial ports. See
Hardware Features starting on
page 13 for the CF card slot location.
Follow these steps to load a CF card.
1. Loosen the two screws that secure the CF card slot cover.
2. Remove the CF card slot cover.
3. Insert the CF card into the slot until it is firmly seated.
4. Reattach the CF card slot cover.
5. Tighten the two screws to secure the slot cover.
B
C
C
C
A
A
A
Integrated Display
Model Shown
IMPORTANT The CF card slot is a bootable slot for DOS and Linux operating systems but not
for Windows operating systems.
You can insert or remove a FAT32 formatted CF card from this slot while the
computer is on. For a NTFS formatted CF card, use the Windows ‘Safely Remove/
Eject Media’ process.
ATTENTION: When properly seated, more than 80% of the CF card easily
inserts into the slot before you encounter resistance. If you encounter
resistance before then, remove the card, rotate it 180°, and reinsert.
Do not force the card into the slot. Forcing the card into the slot can
damage the connector pins.