Rockwell Automation 6180W-xxxx VersaView Workstation User Manual - Manual (Page 49)

Publication 6180W-UM001H-EN-P - August 2007
Replace System Components 49
Add or Remove Memory
1. Disconnect power from the computer.
2. Remove the back cover on the 1500W or non-display computer,
or the top cover on the 1200W.
3. Remove any retaining brackets blocking access to the memory
module.
The DIMM sockets are near the top of the CPU board.
4. Remove the existing memory modules from the CPU card by
clipping the cable tie and pressing outward on the retaining
latches.
5. To install a new DIMM, hold the module by the edges as you
remove it from its anti-static package.
6. Position the DIMM so that the small notches in the bottom edge
of the DIMM align with the notches in the DIMM socket on the
CPU card.
The retaining latches must be fully disengaged, or open, when
you install a DIMM.
7. Press down firmly and uniformly on the DIMM to seat it in the
socket.
The latches must engage in the DIMM slot to secure the DIMM.
8. Replace the tie wrap around the DIMM and latches to fully
secure the DIMM.
9. Replace the cover.