Rockwell Automation 6180W-xxxx VersaView Workstation User Manual - Manual (Page 48)

Publication 6180W-UM001H-EN-P - August 2007
48 Replace System Components
Install the Drive
1. Slide the drive into the drive cage from the front, aligning the
screw holes.
2. Fasten the drive to the floppy drive bracket with four screws.
3. Reinsert the driver cage into the chassis making sure to engage
lock points.
4. Fasten drive cage with two screws on outside of chassis, next to
the new drive.
5. Connect the flat cable, audio cable and power cable to the drive.
6. Reinstall the back cover.
Replace the Memory
Modules The CPU board has two 168-pin sockets. Each socket supports a
single or double-sided 3.3V Dual In-Line Memory Module (DIMM).
For memory replacement or expansion, use the Allen-Bradley 512 MB
DIMM memory module, catalog number 6189V-DIMM512.
Guidelines for Replacing Memory
•
Always handle the memory cards by the ends, not by the
memory module contacts.
•
Store memory in a sealed anti-static bag when it is not installed.
•
Never install or remove memory with the power turned on.
TIP
We recommend that you use only qualified Allen-Bradley parts.
ATTENTION
ESD can damage the computer and components. Make sure you
work in a static-safe environment and wear a grounding strap
whenever handling circuit boards, power supply, memory
modules, or other internal components.