Rockwell Automation 6180P-xxxx Integrated Display Computers with Keypad User Manual - Manual (Page 43)

Rockwell Automation Publication 6180P-UM001C-EN-P - February 2014 43
Component Replacement Chapter 4
13. Secure the new add-in board in place.
a. Extend the clamp to the desired length (L).
b. Tighten the hold-down clamp screw (M).
c. Bend the clamp against the add-in card to secure it in place (N).
d. Lock the clamp screw on the hold-down bar (O).
14. Refer to any installation instructions that came with the add-in card to
verify that all installation steps are followed.
15. Follow the steps for Post-configuration on page 35 .
Replace or Add
Memory Modules The motherboard of the computers has two dual-channel DDR-II DIMM slots
that support up to 2 GB per slot with 4 GB maximum system memory.
Figure 9 - Memory Module Slots and Module Alignment
A
L
N
M
O
Retaining Latch
Keyed Surface
of DIMM Slot