Rockwell Automation 6180P-xxxx Integrated Display Computers with Keypad User Manual - Manual (Page 38)

38 Rockwell Automation Publication 6180P-UM001C-EN-P - February 2014
Chapter 4 Component Replacement
3. Remove the HDD module from its tray.
a. Remove the four mounting screws from the bottom of the tray (C).
b. Detach the tray from the existing HDD module (D).
4. Install the new HDD module to the tray.
a. Install the new HDD module with
the PCB-side down.
b. Fasten the drive tray over the HDD
module (E).
c. Secure the drive tray to the module
with the four mounting screws (F).
Torque the screws to 0.59 N•m
(5.2 lb•in).
5. Return the HDD assembly into its bay
(G).
6. Tighten the two captive thumbscrews of
the drive assembly to secure it to the computer (H).
7. Follow the steps for Post-configuration on page 35 .
ATTENTION: Mechanical shock can damage a drive. Do not drop or
bump the drive.
Drive Tray
Mounting Screws (4)
C
C
C
C
D
F
F
F
F
E
Existing
HDD Module
New
HDD Module
G
H
H