Rockwell Automation 2755-G6-D Scanner with RS-232 Option - Manual (Page 101)

Index
I–2
F
Factory Default Settings, 4–7
G
General Setup Parameters, 2–3
autosense mode, 5–7
beeper operation, 5–4
capture count, 5–5
external trigger operation, 5–8
power consumption, 5–3
spotter beam, 5–6
system status, 5–1
H
Hand-Held Mode, 2–2
I
Inspecting Scanner Cables, E–1
Intercharacter Delay, 6–10
Interface Cable
installing, 4–2
removing, 4–3
Interface Cables, 2–6
pinouts, D–1
Interleaved 2 of 5
disable, 8–10
enable with or without
check digit, 8–10
maximum length, 8–11
minimum length, 8–11
L
Label Buffering, Serial Transmission
full buffering, 6–11
no buffering, 6–11
one label buffering, 6–11
Label Lengths, 8–1
LED Indicators, 3–2
Good Read, 3–2
Scanning, 3–2
M
Maintenance
cleaning window, E–1
inspecting cables, E–1
Message Format Parameters, 2–4,
7–1
code identifier, 7–5
postamble, 7–6, 7–7
preamble, 7–6, 7–7
prefix, 7–2
scanner identifier, 7–4
suffix, 7–3
O
Operating Modes
autosense mode, 2–2
hand-held mode, 2–2
Operating Ranges
long range scanner, 3–4, 3–5
standard range scanner, 3–4, 3–5
Operating Scanner, 3–6