Rockwell Automation 2711-KA1_KC1_TA1_TA4_TC1_TC4 PanelView Terminals for DOS/Windows - Manual (Page 61)

Chapter 3
Installing Your PanelView Terminal Installing Your PanelView 1200 Terminal
Chapter 3
3-6
Attention The electronic components in the PanelView 1200
terminal are extremely sensitive to static electricity and may be
permanently damaged by electrostatic discharges.
If you’re not using an anti-static mat or wrist strap, follow these
precautions before you touch any components inside a PanelView 1200
terminal:
assume your body is always carrying an electrostatic charge
frequently touch any grounded metal surface to discharge yourself
wear cotton clothes, not wool or synthetic fabrics
don’t move too much or scuff your feet when walking on carpets
be extra careful in low-humidity environments
4 Open up the PanelView 1200 terminal logic drawer. Remove the two
screws located near the bottom back of the unit to drop the tray
containing the board, as shown in the following figure.
Figure 1.6
Opening the Series E PanelView 1200 Terminal
21171
Color Back Panel Monochrome Back Panel
Remove these
two screws to access
the logic board.
......
........
......
........
5 Socket U2 is labeled User Memory as shown in the following figure.
This figure shows the jumpers JP1 and JP2 in the EPROM/EEPROM
position.
6 Set the jumpers JP1 and JP2 to the right-most pins, labeled
EPROM/EEPROM (as shown in the following diagram).