Preface, Purpose of this manual, Preface purpose of this manual – Rockwell Automation 1734-XXXX POINT I/O and ArmorPOINT I/O DeviceLogix User Manual User Manual
Page 7
5
Publication 1734-UM015A-EN-E - November 2009
Preface
Purpose of This Manual
This manual describes how to install, configure, and troubleshoot your
POINT I/O DeviceLogix and ArmorPOINT I/O DeviceLogix modules.
POINT I/O and ArmorPOINT I/O modules can be used in EtherNet/IP,
DeviceNet, and ControlNet systems. As such, you may need to refer to other
publications in addition to this one.
When using POINT I/O DeviceLogix modules with a communication
adapter, use this manual in conjunction with the user manual for the adapter
you are using as shown in the table.
POINT I/O DeviceLogix modules are not compatible with the PROFIBUS
adapter.
When using ArmorPOINT I/O DeviceLogix modules with a communication
adapter, use this manual in conjunction with the user manual for the adapter
you are using as shown in the table.
ArmorPOINT I/O DeviceLogix modules are not compatible with the
PROFIBUS adapter.
The modules in this manual are DeviceNet-ready. Each module can exist on
the DeviceNet network as one of the following:
•
An individual node
•
With an adapter (catalog number 1734-ADN or 1734-ADNX) as a
single node
For applications using these modules in a network with a 1734-PDN
DeviceNet Communication Interface, or a 1734D-xx POINTBlock I/O
module, this user manual is the primary documentation.
When Using POINT I/O
Modules on This Network
Refer to
Publication for
Catalog No.
Publication No.
DeviceNet network
DeviceNet adapter
1734-ADN
1734-ADNX
ControlNet network
ControlNet adapter
1734-ACNR
EtherNet/IP network
EtherNet/IP adapter
1734-AENT
When Using ArmorPOINT
I/O Modules on This
Network
Refer to
Publication for
Catalog No.
Publication No.
DeviceNet network
DeviceNet adapter
1738-ADN
1738-ADNX
ControlNet network
ControlNet adapter
1738-ACNR
EtherNet/IP network
EtherNet/IP adapter
1738-AENT
1738-AENTR