Parameters on the parameters tab – Rockwell Automation 1734-XXXX POINT I/O and ArmorPOINT I/O DeviceLogix User Manual User Manual
Page 55

Publication 1734-UM015A-EN-E - November 2009
Configuring POINT I/O and ArmorPOINT I/O DeviceLogix modules using RSNetworx for DeviceNet 53
Parameters on the Parameters tab
Parameters on the Parameters tab
Parameter
Description
Data -
Input/Output
This parameter is the same as the first byte of the Produced I/O
assembly. It is the state of the eight I/O points.
Data - Consumed
Bits
This parameter is the same as the second byte of the Consumed I/O
assembly. It is the state of the Consumed Network Bits or User
Defined Bit Data.
Consumed
Analog Word #xx
These eight parameters are from the Consumed I/O assembly. They
contain the state of the Consumed Network Words or User Defined
Word Data.
Network Status
Override
This is a legacy Parameter for DeviceLogix and ZIP. It shows the state
of Network Status Override.
Comm Status
Override
This is a legacy Parameter for DeviceLogix and ZIP. It shows the state
of Communication Status Override.
Peer Status
The eight bits in this parameter are used to determine the connection
status of a peer.
ZIP Security Key
This is a legacy parameter for DeviceLogix and ZIP (Zone Interlock
Parameters). The ZIP Security Key is a 16-bit value used to uniquely
identify a module and its configuration. This value can be used in the
DeviceLogix program to verify that the configuration of a peer has not
changed. More details on using the ZIP Security Key will be provided
in the later part of this chapter.