Rockwell Automation 1770 DH,DHII,DH485 CABLE - Manual (Page 58)

Chapter 3
Constructing a Data Highway or
Data Highway Plus Cable System
3-26
4. Install the jack or plug connector.
a. Slip the shield dielectric over the shield assembly.
Shield
Shield Dielectric
18738
b. Push the connector body over the shield dielectric and engage the
threads of the wrench crimp nut.
ATTENTION: In the next step, be sure to adhere to the torque
specification. Over-tightening the crimp nut may damage the
connector, and under-tightening the crimp nut may create a loose
connection on the shielding.
c. Tighten the wrench crimp nut to 30-40 lbs-in
(3.4-4.5 N-m).
Now that the connector body is assembled, you must check for electrical
continuity as explained in the next procedure. Do not remove the cable segment
from the vise.