Preface, Purpose of this manual, Who should use this manual – Rockwell Automation 1734-XXXX POINT I/O Digital and Analog Modules and POINTBlock I/O Modules User Manual
Page 5: Preface purpose of this manual
Rockwell Automation Publication 1734-UM001E-EN-P - July 2013
Preface
Purpose of This Manual
This manual describes how to install, configure, and troubleshoot your
POINT I/O modules.
The POINT I/O modules in this manual are DeviceNet ready. Each module can
exist on the DeviceNet network as one of the following:
•
As an individual node
•
With an adapter (catalog number 1734-ADN or 1734-ADNX) as a single
node
When using these POINT I/O modules with an adapter, use this manual in
conjunction with the user manual for the adapter you are using as shown in the
table.
For applications using these modules in a network with a 1734-PDN DeviceNet
Communication Interface, or a 1734D-
xx POINTBlock I/O module, this user
manual is the primary documentation.
Who Should Use This
Manual
In this manual, we assume you know how to do the following:
•
Use RSNetWorx software or similar configuration software to set up and
calibrate these modules.
•
Have the capability to download and use electronic data sheet (EDS) files.
If you do not, refer to your software documentation or online help before
attempting to use these modules.
When Using POINT I/O Modules
on This Network
Refer to User
Manual for
Cat. No.
Publication
No.
DeviceNet network
DeviceNet adapter
1734-ADN
1734-ADNX
ControlNet network
ControlNet adapter
1734-ACNR
EtherNet/IP network
EtherNet/IP adapter
1734-AENT
PROFIBUS network
PROFIBUS adapter
1734-APB