Rockwell Automation 1734-XXXX POINT I/O Digital and Analog Modules and POINTBlock I/O Modules - Manual (Page 199)

Rockwell Automation Publication 1734-UM001E-EN-P - July 2013
Configure POINT I/O Modules for DeviceNet Networks 207
For example, assume you have five POINT I/O modules in a line, and the address
of the first module is 10. After the Sequential Address command is sent to the
first module, the node address of the line is 10, 11, 12, 13, and 14.
Using Third-party Configuration Software
When using third-party configuration software, load the EDS files into the
software and follow the designers instructions.
Configure Digital Modules
Using RSNetWorx Software To configure digital input modules, proceed as follows, noting that input
modules use dialogs similar to the one for the 1734-IB4 modules used in this
procedure.
1. Open your RSNetWorx for DeviceNet software.
2. Using the selections on the left, construct your system.
If your network is up, click Browse.
3. After setting up your system, double-click the module you want to
configure.
If you are online, upload the configuration.