Rockwell Automation 1775-SRx PLC-3 FAMILY PROG CONTRL - Manual (Page 9)

Step
2
Publication 1775Ć10.1 - March 1996
Install Power Supply
Install 1775ĆP3 Power Supply into the PLCĆ3/10
(or singleĆchassis PLCĆ3)
a
PLCĆ3/10 chassis
CF2
CF1
backplane
20417ĆM
Feed the dc power cable under the
module guides along the backplane.
Install the dc power cable.
Squeeze the side tabs of the plugs
as you connect them to the backplane.
b
Plug the cable assembly into the connectors on the powerĆsupply module,
connect the 8Ćpin control connector cable to the powerĆsupply module, and
insert the powerĆsupply module in the rightĆmost slot of the chassis.
PLCĆ3/10 chassis
20418ĆM
Insert and tighten all six screws
on the outside of the chassis.
P2
P1
1775ĆP3
powerĆsupply
module
Squeeze the side tabs of the plugs
as you connect them to the module.
Connect the cable
at the 8Ćpin connector.
When you install the 1775ĆP3 power supply into a PLCĆ3/10, if
there is a jumper plug (PN 967447Ć01) installed on the
8Ćpin controlĆconnector terminals, remove and discard it.