Rockwell Automation 1770-KF2 Data Highway or Highway Plus Interface Module User Manual - Manual (Page 167)

Error Reporting
Chapter 7
7Ć12
Code (If Applies)
EXT STS STS Meaning
Error
Code
194
Expression is too complex.
199 Attempt to divide by zero.
200 Bad port specifier. That is, the character following the #" is other
than H", h", M", or m".
201 User symbol used as part of remote address specification.
202 Undefined data following assignment command. This error would
occur, for instance, if the modifier UNRPOT were used instead of
UNPROT.
203 Error in remote specification.
1. A character other than @" or $" following the station
number specification (... = #H045*T...).
2. Something other than EOL, PROT, or UNPROT following a
remote source add. (.... = #H012$S5:8 + 9).
204 ThirdĆparty transfer. That is, in an assignment command, both
the source and the destination were remote addresses.
205 Error in evaluating a PLCĆ2 address, or PLCĆ2 address greater
than 65,535 bytes.
206 Zero range specified in an assignment command.
207 Word range specified in destination address.
208 Destination and source addresses disagree in type.
209 Not of Data Highway message type.
210 Use of a nonĆPLCĆ3 type address in a local address operand.
211 In an assignment command, one of the local files does not exist,
or the word specified is beyond the end of the file.
213 A local file exists, but the action specified refers to addresses
beyond the end of the file. Possible causes include:
1. In a word assignment statement, the offset is greater than
the file size.
2. In a word range assignment statement, the sum of the base
address and the offset is greater than the total file size.
3. In a file assignment statement, the destination file is smaller
than the source file. If the source file is remote, a single
packet will be fetched from the remote station's file.
214 Local source and destination files differ in size.