Rockwell Automation 1746-BTM Barrel Temperature Control Module User Manual User Manual
Barrel temperature control module
Table of contents
Document Outline
- 1746-UM010B-EN-P
- Important User Information
- European Communities (EC) Directive Compliance
- Summary of Changes
- Preface
- Table of Contents
- 1 - Getting Started
- 2 - Installing and Wiring
- 3 - Configuring the Module
- Loop Operation Mode
- Type of Loop Input
- Enable Loop Alarms
- TC Break Response
- Loop Autotune Gains Level
- Barrel/Non-barrel Control
- Inner/Outer Zone Selection
- High/Low CV Limits
- TC Break Control
- Standby Setpoint
- Heat/Cool Minimum On-times
- Heat/Cool TPO Period
- PV Rate and Associated Alarm
- High/Low Temperature and Deviation Alarms
- Alarm Dead Band
- Thermal Integrity Loss Detection
- Ramp Rates
- Non-barrel Autotune Disturbance Size
- Configuration Block, M1 File, Loops 1-4 N10:0-100
- Startup Aggressiveness factor
- Ramp Rates
- Chapter 4
- 4 - Setting Autotune and Gains Values
- 5 - Control and Autotune a Loop
- 6 - Monitoring Status Data
- 7 - Calibrating the Module
- 8 - Troubleshooting the Module
- 9 - Sample Program
- Index
- Back Cover