Rockwell Automation Logix5000 Controllers Nonvolatile Memory Programming Manual - Manual (Page 28)

Chapter 2 Use a memory card reader
When you store a project to a memory card, you define:
• When to load the project (On Power Up, On Corrupt Memory, User
Initiated).
• What mode to set the controller (if the keyswitch is in REM and the Load
mode is not User Initiated).
To assign a project to load from the memory card, edit the Load.xml file on the
card by following the steps that match the numbers in the illustration.
Description
To change the load parameters for a project, use a text editor to open the XML file with the same name as the
project.
Edit the Load Image option of the project.
To set the Load Image option to: Then enter:
On Power Up ALWAYS
On Corrupt Memory CORRUPT_RAM
User Initiated USER_INITIATED
Change the load
parameters
28 Rockwell Automation Publication 1756-PM017F-EN-P – October 2014