Rockwell Automation Logix5000 Controllers Nonvolatile Memory Programming Manual - Manual (Page 19)

Store and load a project by using a memory card Chapter 1
2. Did the Connected To Go Online dialog box open?
If Then
No a. Put the controller in Program mode (Rem Program or Program).
b. On the Online toolbar, click the Controller Properties icon.
Yes Put the controller in Program mode (Rem Program or Program). You can either:
• Click the General tab on the Connected To Go Online dialog box.
• Use the keyswitch on the front of the controller.
3. On the Controller Properties dialog box, click the Nonvolatile Memory
tab.
4. Click Load/Store.
Rockwell Automation Publication 1756-PM017F-EN-P – October 2014 19