Store a project – Rockwell Automation Logix5000 Controllers Nonvolatile Memory Programming Manual User Manual

Page 15

Store and load a project by using a memory card Chapter 1

This section explains how to store a project on the memory card of the controller.

ATTENTION: During a store operation, all active servo axes are turned off. Before you store a project,

make sure that this does not cause any unexpected movement of an axis.

Before you store the project:

• Make all the required edits to the logic.
• Download the project to the controller.
• Schedule your ControlNet networks.

Follow these steps to store a project.

1. Go online with the controller.

2. Put the controller in Program Mode (Rem Program or Program).

3. On the Online toolbar, click the Controller Properties icon.

Tip:

For 1756-L7x controllers only, Energy Storage instead of Battery OK appears beside the Controller
Properties icon. See the

ControlLogix System User Manual

, publication

1756-UM001

for information on

the Energy Storage Module.

4. On the Controller Properties dialog box, click the Nonvolatile Memory

tab and then click Load/Store.

Store a project

Rockwell Automation Publication 1756-PM017F-EN-P – October 2014