Rockwell Automation Logix5000 Controllers Nonvolatile Memory Programming Manual - Manual (Page 22)

Chapter 1 Store and load a project by using a memory card
Follow these steps to remove a project from a memory card.
1. Go online with the controller.
2. On the Online toolbar, click the Controller Properties icon.
Tip: For 1756-L7x controllers only, Energy Storage instead of Battery OK appears adjacent to the controller
properties icon. See the
ControlLogix System User Manual , publication 1756-UM001 , for information on the
Energy Storage Module.
3. On the Control Properties dialog box, click the Nonvolatile Memory tab.
4. Is Load Image set to User Initiated?
If Then
No Go to Change the load image option on page 24 .
Yes Go to Clear the project from the controller on page 25 .
Clear a memory card
22 Rockwell Automation Publication 1756-PM017F-EN-P – October 2014