2 - use a memory card reader, Introduction, Change which project loads – Rockwell Automation Logix5000 Controllers Nonvolatile Memory Programming Manual User Manual

Page 27: Chapter 2, Use a memory card reader, Introduction change which project loads

Chapter 2

Use a memory card reader

A sample controller project that reads and writes a memory card is available with
the Logix Designer application. In the application, from the Help menu, choose

Vendor Sample Projects to display a list of available sample projects.

A memory card can store multiple projects. By default, the controller loads the

project that you most recently stored, according to the load options of that

project.

To assign a project to load from the memory card, edit the Load.xml file on the

card by following the steps that match the numbers in the illustration.

Description

To change the project that loads from the card, use a text editor to open the Load.xml file.

Edit the name of the project that you want to load.
• Use the name of an XML file that is in the CurrentApp folder.
• In the CurrentApp folder, a project is comprised of an XML file and a P5K file.

Introduction

Change which project loads

Rockwell Automation Publication 1756-PM017F-EN-P – October 2014