Rockwell Automation 1609-ENET Ethernet Network Card Quick Start - Manual (Page 24)

24 Rockwell Automation Publication 1609-QS002A-EN-P - May 2014
Appendix A EtherNet/IP Object Service
Return Code Name Description
Service
0x00 Success Service was successfully performed by the object specified.
0x0F Privilege violation A permission/privilege check failed
0x08 Service not
supported The requested service was not implemented or was not defined
for this Object Class/Instance.
Forward
Open
0x01 Connection failure A connection related service failed along the connection path.
Attribute Single
Get/Set
0x14 Attribute not
supported The attribute specified in the request is not supported
Get 0x2C Attribute not
gettable A request to read a non-readable attribute was received
Set 0x13 Not enough data The service did not supply enough data to perform the specified
operation.
Set 0x15 Too much data The service supplied more data than was expected
Set 0x0E Attribute not
settable A request to modify a non-modifiable attribute was received.
Set 0x03 Invalid parameter
value See Status Code 0x20, which is the pred value to use for this
condition.
Assembly
Member
Insert /
Remove
0x05 Path destination
unknown The path is encing an object class, instance or structure element
that is not known or is not contained in the processing node.
Path processing shall stop when a path destination unknown
error is encountered.
Instance
Create/Delete 0x03 Invalid parameter
value See Status Code 0x20, which is the pred value to use for this
condition.