Rockwell Automation 1329I Integrated AC Drive/Motor, Series A - Manual (Page 8)

1-2 Step 1 - Identify Your Unit
1329I-5.0 Integrated Drive/Motor — January, 1999
1.1 1329I Standard Unit
The standard unit, shown in Figure 1.1, provides a local display for speed or percent
load, and diagnostic information. A control signal terminal block in the Drive Section
connects to a user-supplied remote operator control station.
Figure 1.1
1329I Standard Unit
1.1.1 Standard Unit Display Description
The four-character, seven-segment display shows the drive output speed in RPM or
percent load, and displays active fault codes. Speed in RPM is the default display. To
display percent load, see Section 7.4.
If a fault occurs, the unit displays the corresponding fault code. Refer to Chapter 11 for
more information about fault codes and corrective actions.
1.1.2 Standard Unit Reverse LED Description
The REVERSE LED indicates the requested direction of motor rotation:
If the motor is turning and you request a change to motor direction, the LED turns on
or off immediately even though it may take some time for the motor to decelerate and
begin turning in the opposite direction.
Motor Section Drive Section
Display Reverse LED
LED Status Definition
OFF The requested direction of motor rotation is forward.
(The 1329I unit is shipped with the forward direction defined as CCW shaft
rotation as viewed from the motor shaft end.)
ON The requested direction of motor rotation is reverse.
(The 1329I unit is shipped with the reverse direction defined as CW shaft
rotation as viewed from the motor shaft end.)