Rockwell Automation 1441-DYN25-MBAL Balancing Extension Module for the Dynamix 2500 - Manual (Page 50)

50 Rockwell Automation Publication 1441-UM004A-EN-P - May 2011
Chapter 2 Balancing Extension Module
How to Perform Two-plane Balancing
After setting up your balance measuring equipment, and setting the data
collector’s balancing measurement parameters, you are ready to perform the
two-plane balancing procedure.
Perform the Initial Runs
The two plane procedure is slightly different, depending on whether you are
using one transducer or two. When using one transducer, Plane 1 and Plane 2
runs are performed sequentially, allowing you to move the transducer between
the planes. When using two transducers, it is assumed the transducer positions
remain fixed and all Plane 1 and 2 runs occur simultaneously.
When you use two transducers with two plane balancing, the measurements are
displayed simultaneously.
IMPORTANT Anytime during the initial run, you can do the following:
•Press F4 (Esc) to exit the balancing program.
•Press 0 (Shift) and F1 (Go to) simultaneously to go back to a
previous step in the balance run.
See Move Around in a Balance Run on page 60 for details.
•Press F2 (Summary) to display the results in the Vibration
Summary Table.