Safety, Certifications – Rockwell Automation 1606-XLS240UPSD Power Supply Reference Manual User Manual
Page 19

All parameters are specified at an input voltage of 24V, 10A output load, 25°C ambient and after a 5 minutes run-in time unless noted otherwise.
It is assumed that the input power source can deliver a sufficient output current.
Rockwell Automation Publication 1606-RM017A-EN-P — February 2014
19
Bulletin 1606 Switched Mode Power Supplies
Product certification information (including Certificates and declarations of Conformity) can be found at
www.ab.com/certification
.
20. Safety
Output voltage
SELV
IEC/EN 60950-1
PELV
EN 60204-1, EN 50178, IEC 60364-4-41
Max. allowed voltage between any input, output or signal pin and ground:
60Vdc or 42.4Vac
Class of protection
III
PE (Protective Earth) connection is not required
Isolation resistance
> 5MOhm
Power port to housing, 500Vdc
Dielectric strength
500Vac
Power port to signal port
500Vac
Power port / signal port to housing
Touch current (leakage current)
The leakage current which is produced by the DC-UPS itself depends on the input
voltage ripple and need to be investigated in the final application.
For a smooth DC input voltage, the produced leakage current is less than 100 μA.
21. Certifications
UL 508
LISTED E56639 listed for use in the U.S.A. (UL 508) and
Canada (C22.2 No. 14-95)
Industrial Control Equipment
IND. CONT. EQ.
18WM
UL 60950-1
RECOGNIZED E168663 recognized for use in the
U.S.A. (UL 60950-1) and Canada (C22.2 No. 60950)
Information Technology Equipment, Level 3
ISA 12.12.01, CSA
C22.2 No. 213
RECOGNIZED UNDER FILE NUMBER E244404 for use in the U.S.A.
(ISA 12.12.01) and Canada (C22.2 No. 213)
Hazardous Location Class I Div. 2 - Groups A, B, C, D
EN 60950-1, EN 61204-3
Complies with CE EMC and CE Low Voltage Directives
Marine RINA
RINA (Registro Italiano Navale) certified. See below for linj
to the Certificate.
GOST R certification is applicable for products intended for sale
and use withing Russia. See below for link to Certificate.
GOST R
C-TICK
C-tick compliance is for products intended for sale and use within
the Australian market. See below for link to the C-tick Declarations
of Conformity.