Rockwell Automation 1408-EMxx PowerMonitor 1000 Unit - Manual (Page 36)

36 PowerMonitor 1000 Unit
Rockwell Automation Publication 1408-IN001E-EN-P - September 2013
5. Press the Enter key three times.
The following menu appears.
6. To enter a menu item, backspace to delete the default value 1, type the number of the
menu item, and press Enter.
In a submenu, the HyperTerminal communication tool presents parameters one at a
time. To change parameter values, enter the unit password as the first parameter. To enter
the password, backspace to delete the -1 and enter the correct password (0 is the default).
To view the existing settings without making changes, leave the password unchanged.
7. Press Enter to accept the password and present the next parameter.
To change any parameter, backspace over the displayed parameter and enter the new
value. Press Enter to save and move to the next parameter.
The HyperTerminal communication tool displays a status message when all parameters
are entered.
• Write operation finished successfully
This indicates the setup parameters have been written to the power monitor.
• Write error occurs with element 0
This indicates that the correct password was not entered.
• Write error occurs with element n
This indicates that the value entered for parameter n is outside the acceptable range
of values.
After the message, this prompt appears:
Edit… Configuration Table again?
Type Y for more editing, otherwise type any other key to exit.: N
8. Type Y to review or edit the selected setup parameters.