Rockwell Automation 1408-EMxx PowerMonitor 1000 Unit - Manual (Page 34)

34 PowerMonitor 1000 Unit
Rockwell Automation Publication 1408-IN001E-EN-P - September 2013
7. Press to change the value of the year.
The power monitor is now in Edit mode, indicated by the presence of the highlight
cursor. Change the year value and press to save it or to discard
changes.
See
Edit a Parameter on page 30 if you need help with this.
8. Select the next item in the configuration menu by pressing .
Set the month in the same way.
Continue setting the remaining parameters in the same way.
• Navigate to the top menu display
• then then to access the password screen
• Enter the correct password to access Program mode
• Navigate to the desired menu using , and
• selects a parameter for editing
• or increments or decrements the value of the highlighted digit
• and together move the highlight cursor
• saves your changes; discards them
• several times to the top menu to access Display mode
View Data with the Display
You may also view power monitor wiring diagnostics, metering, status and setup data using the
display. To view data, select Display (instead of Setup) from the top menu and navigate through
the menus as in the setup example. Press and to navigate into and out of
submenus and and to select items within a submenu. Display mode does not
permit you to change any parameter. Metering data available depends on the model of your
power monitor.
PowerMonitor 1000 RS-485 STATUS
RX TX Mod Net
Set Date
Year

2005
8