Rockwell Automation 1502 Medium Voltage 400A Contactor - Series E - Manual (Page 50)

50 Rockwell Automation Publication 1502-UM052H-EN-P - June 2013
Chapter 4 Maintenance
Figure 44 - Removal of Mechanical Trip Mechanism
6. Remove the “E” clip and washer from the latch lever assembly shaft and
then remove the shaft ( Figure 45 ). Remove the latch lever assembly from
the mechanical latch base. Note that the return spring is “seated” on the
right side of the mechanical latch base. (
Note: Contactor not shown for
clarity).
Figure 45 - Removal of Latch Lever Assembly
7. Using a 5/16” socket, remove the #10-32 hardware holding the stainless
steel guide/stop plate in place, and then remove the guide/stop plate
(
Figure 46 ). (
Note: Contactor not shown for clarity).
Figure 46 - Removal of Guide/Stop Plate
Mechanical Trip
Mechanism
¼-20 Hardware
(Qty 2)
Contactor
Return Spring Seat
Shaft
“E” Clip and Washer
Latch Lever Assembly
Guide/Stop Plate
#10-32 Hardware