beautypg.com

Rockwell Automation 1336S, 1336F, 1336E, 1336T, 1336-SN-SP18A Snubber Board Kit User Manual

Page 45

background image

1336-5.39 – August, 1999

I-45

1. Disconnect the following from the Main Control Board:

J1 connector

J2 ribbon cable connector

J8 connector

8-pin connector from the HIM Mounting Plate on the Main
Control Board

Ground wires from terminal block TE

Chassis ground wire at the top-right corner of the Main
Control Board Mounting Plate

2. Slide the LEM harness out of the clip located at the top-left of the

Main Control Board Mounting Plate.

3. Remove the two screws fastening the bottom of the Main Control

Board Mounting Plate to the standoffs.

4. Remove the nuts fastening the top of the Main Control Board

Mounting Plate to the Gate Driver Board Mounting Plate.

5. Lift the Main Control Board Mounting Plate out of the drive.

6. Continue with “Gate Driver Board and Precharge Board

Mounting Plates” on page I-50.