Rockwell Automation 20G PowerFlex 750-Series Power Option Cabinets - Manual (Page 19)

Rockwell Automation Publication 750-IN030B-EN-P - October 2014 19
PowerFlex 750-Series Power Option Cabinets
Gasket Kit Installation The adhesive backed gasket kit is available to provide a seal between cabinets
when an IP54, NEMA 12 enclosure rating is required.
Table 18 - Contents 20-750-PBAY-IP54 Gasket Kit
1. Review the gasket pattern and clearances in
Figure 2 or Figure 3 .
Note the top and bottom corner seam detail in the figures.
2. Press the gasket material onto the power option cabinet surface.
Remove the protective backing from the gasket material as you apply it to
the surface.
ATTENTION: If the gasket material is applied to the cabinet prior to shipment to the
installation site, protect the gasket from damage. If the gasket material is damaged, the
integrity of the seal can be lost.
Description Part No. Quantity
Adhesive backed foam gasket tape PN-207211 1 roll
Protective Backing
Gasket