Rockwell Automation 150-E SMC Elevator Users Manual - Manual (Page 9)

Rockwell Automation Publication 150-UM009D-EN-P - February 2011 9
Chapter
2
Installation & Wiring
Unpacking Prior to installation, unpack the starter panel from its packaging and perform a
complete visual inspection of the panel. Inspect all components including the
controller, wiring, and fault contactor for damage related to shipping and
handling. Claims for damage must be made to the carrier as soon as possible after
receipt of the shipment.
Mounting The small footprint of the starter panel makes it ideal for mounting in the same
space previously occupied by legacy solid state starters and traditional Full
Voltage starters. The starter panel does not require mounting requirements
beyond the basic footprint of the panel.
The product may incorporate a small cooling fan. There are no additional cooling
requirements for the product. However, it is good practice to leave at least 6
inches (15.24 cm) of free space above and below the unit for ideal air flow.
Dimensions Figure 2 - Panel Dimensions for 32, 51, & 64 A Elevator Panels
➊ This screw is intended to secure a prepared bonding conductor (e.g., a bonding conductor with a crimped-
on lug) or a suitable terminal for connection of an unprepared bonding conductor (e.g., a bonding
conductor with a stripped wire end). This screw is not intended for a direct field wiring connection of an
unprepared bonding conductor or equipment grounding conductor.
4.56
(115.7)
5.67
(144.0)
7.01
(178.0)
6.50
(165.1)
5.00
(127.0)
4X Ø 0.220 thru
(5.6)
CAT. XXXXXXXX SER. B
T6 T4 T5
1