Rockwell Automation 20-750-PBUS Profibus DPV1 Option Module - Manual (Page 12)

12 Rockwell Automation Publication 750COM-UM004B-EN-P - September 2012
Chapter 1 Getting Started
Features The features of the option module include the following:
• Captive screws to secure and ground the option module to the drive.
• Switches to set a node address before applying power to the drive—or you
can disable the switches and use an option module parameter to configure
the node address.
• Compatibility with various configuration tools to configure the option
module and host drive, including the following tools:
– PowerFlex 20-HIM-A6 or 20-HIM-C6S HIM (Human Interface
Module) on the drive, if available
– Connected Components Workbench software, version 1.02 or later
– DriveExplorer software, version 6.01 or later
– DriveExecutive software, version 5.01 or later
– DriveObserver software, version 5.01 or later
– ControlFlash software, version 7.00 or later
– Third party Profibus configuration software, such as Prosoft
Configuration Builder
• Status indicators that report the status of the option module and network
communication. They are visible when the drive cover is open or removed.
• Parameter-configured 32-bit Datalinks in the I/O to meet application
requirements (16 Datalinks to write data from the network to the drive,
and 16 Datalinks to read data to the network from the drive).
• Acyclic Messaging support.
• Master-Slave hierarchy that can be set up so that the option module and
PowerFlex 750-Series drive transmit data to and from a master on the
network.
• User-defined fault actions to determine how the option module and
connected drive respond to the following:
– I/O messaging communication disruptions (Comm Flt Action)
– Controllers in Idle mode (Idle Flt Action)
– Acyclic messaging