Rockwell Automation 20D-MDI-C1 Multi-Device Interface Option Board for PowerFlex 700S Drives - Manual (Page 7)

Multi-Device Interface Option Board for PowerFlex® 700S Drives 7
Remove the Phase II Cassette Covers (All Drive Sizes)
Step 5: Remove the
Existing MDI Option Board
Proper tightening torque
for reassembly is 6 lb.•in.
Removing the Side Covers
Task Description
Loosen the screws on the front cover and
remove the cover.
Loosen the screws on the side of the rear cover
and remove the cover.
A
B
=
A
B
Task Description
Remove the screw that secures the board to the control frame.
Loosen the captive screws.
Remove the MDI Option board, through-board pin connectors and insulating washer from
main Control board.
Remove the stand-offs from main Control board (on Phase I drives only).
A
B
C
D
B
C
D
A
Note: Phase I shown.