Yamato Scientific WR600S AutoPure - Manual (Page 6)

INSTALLATION
Unpacking
The different components supplied with the system are shown in figure 2 and are listed below.
(A)
Autopure WR600 water purification system
(B) Electrical power cord
(C) Folder with documents to insert
(D) Tubing 8 mm OD, 5 meters length for :
- inlet water connection
- reject stream for ultrafiltration module
(E) Tubing (6 mm OD), 2.5 meters length for A-10 waste stream
(F) Tubing used when UF module is sanitised
(G) Fitting 1/4“ MNPT - hose barb (MNPT = male national pipe thread)
(H) Fitting 1/2” FNPT - 8 mm OD tubing with screen filter inside
(I) Teflon TM tape
(J) Plastic bag containing elbow fittings
(K) Six sided key used to loosen / tighten point of use arm
Items ordered / obtained separately
(L) Q-Gard purification pack
(M) QUANTUM cartridge
(N) MILLIPAK 40 final filter 0.22 µm size for point of use gun
Checked by Name Signature Date
Verified by
Name Signature Date
Installation of the system
The system can either be placed on a bench or wall mounted. If the system is to be wall mounted, then it is
necessary to first verify that the wall can support the weight of the system. Contact Yamato Technical Service
for further instructions on wall mounting the system.
Some versions of the Autopure WR600 systems require a drain nearby. When a reservoir is used as a feedwater
supply, locate the system and reservoir close together whenever possible.
Note: The pressure regulator and pressure gauge are not supplied with the Autopure WR600 and must be ordered
separately. Contact Millipore Technical Service for more information.
Present ?
yes no