Yamato Scientific WR600S AutoPure - Manual (Page 26)

APPENDIX 1
Interrupting the sanitisation cycle of an UF cartridge
If a sanitant chemical has been introduced into the Autopure WR600 , it is absolutely necessary to let the sanitisation cycle finish.
If no sanitant has been introduced, then the sanitisation cycle can be cancelled by following these instructions.
Press CLEANING for 10 seconds
↓
At the end of the sanitisation cycle, the will go back to its
initial mode of operation.
Purging entrapped air from the UF cartridge.
In either PRE OPERATE or PRODUCT
Press MENU for 2 seconds
↓
press MENU 5 times
Open the point of use trigger to begin the air purge cycle.
The product water from the system will go to the drain via
the reject tubing.
At the end of the air purge, the system will go back into
PRODUCT mode.
Close the point of use trigger (vertical position).
Interrupting the A-10 cleaning cycle
If an A-10 cleaning cycle has been started from the MENU service mode, then it can be cancelled by pressing on the MENU
button.
P R O D . T I M E S E T U P
C O U N T E R : 0 m n
OPERATE/STANDBY MEASURE CLEANING MENU
S A N . C Y C L E 4 2 0 m n
S E R V I C E : U F
A I R P U R G E
OPERATE/STANDBY MEASURE CLEANING MENU
S T A N D B Y
OPERATE/STANDBY MEASURE CLEANING MENU